A3 Industries' Stribog Bullpup Kit Shrinks Carbine, Raises Muzzle Concerns
A3 Industries has built a bullpup conversion kit for the Grand Power Stribog, but only for the 10mm SP10 and .45 ACP SP45 — the 9mm SP9 that just won the 2025 IPSC PCC/Mini Rifle World Shoot doesn't fit.
Snapshot
The kit swaps the Stribog's factory lower for a new bullpup unit, dropping overall length to 16 inches while keeping the carbine's 10mm or .45 ACP chambering. The Firearm Blog reports it installs in about ten minutes and comes with the trigger, selector and other controls already fitted at the factory.
Key points
- Caliber-specific: The conversion only fits the SP10 and SP45 Stribogs; there's no version for the 9mm SP9 that won the recent World Shoot in Slovakia's hands.
- Size and weight: Assembled, the bullpup runs 16 inches overall; the lower alone weighs 2.5 lb, about 6.5 lb with the upper installed.
- Pre-installed hardware: A RAVE-140 trigger (3.5 lb pull, modified for this kit and not swappable), a Lingle Industries bolt catch, an ambidextrous selector and a textured paddle mag release all come fitted from A3.
- Safety note: The Firearm Blog's author flags that the short muzzle sits close to where a support hand naturally rests, and treats the included hand stop as essentially mandatory rather than optional.
- Legal status and availability: The kit itself isn't a firearm and ships direct to buyers, but installing it makes the Stribog an SBR, so NFA rules apply. It's a limited run of 100 units, machined in the USA, priced at $999.95.
Quick take
Shrinking a 10mm or .45 carbine down to 16 inches is a genuinely odd engineering move, and the muzzle-blast proximity issue the source raises seems like the real tradeoff buyers need to weigh before fitting one.
Read the full story: thefirearmblog.com